SG-200

Directions:

Start by gathering all materials. In addition to materials listed in the diagram you will also need a hack-saw (A power band saw will also work), drill, drill bits, PVC Cleaner, and PVC glue.

Step 1: Cut PVC to correct length. PVC comes in 5 and 10 foot chunks, so you may not need to cut the barrel.

Step 2: Drill holes. Drill small holes on top half of barrel. This helps to reduce pressure needed for launch (which will increase power) and keep accuracy at the same time. This is an optional step. You will also need a whole in the end of the end cap for the igniter.

Step 3:Glue connections. Begin on one end of the gun and work towards the other end. First apply the PVC Cleaner to the outside of the pipe and to inside of the fitting. Now apply the glue to the pipe and fittings.

Step 4: Insert igniter into end cap.

Step 5: Watch the movie "Titanic " at least 4 times, or If you aren't a big Leo fan you can just let the glue dry for 12 hours and do what you want.

Step 6: Load Potato,  load fuel, shoot. Laugh historically, repeat step 6.